Time Line & Facts
- 1931: Lewis Construction Company began construction under Bureau of Reclamation
- 1961: Last year railroad in use
- 1962: Tracks dismantled and sold for scrap to Lucia Brothers
- 1984: Nominated to National Register of Historic Places
- Length: 2.6 mi. from gate to the entrance of tunnel 5
- One of two most difficult sections of track to construct, only remaining section of Hoover Dam Railroad system that is not highly disturbed or under water.
- All tunnels are approximately 300 ft. in length, and 25 ft in diameter. The tunnels were oversized to fit penstock sections and large equipment being transported to Hoover Dam.
- Nine steam and four gas locomotives and 71 people were used to operate the system. If was a standard-gauge, 90-pound rail construction that used Oregon fir ties.
- This section was used in the motion picture "The Gauntlet" starring Clint Eastwood and Sondra Looks for a sequence in which they were on a motorcycle being chased by an assassin in a helicopter.
The Story
In 1931 a construction contract was let to Six Companies, Inc., a consortium of six major western firms. Together with the government, they built almost 30 miles of railroad connecting Boulder City with all the facilities needed to build Hoover Dam (eg., cement mixing plants, quarry pit, gravel sorting plant).
The Hoover Dam construction railroad system had three segments. The first, from Las Vegas to the Boulder City site, was built and operated by the Union Pacific Railroad.
The second segment was built by the U.S. Government. It ran from Boulder City down Hemenway Wash to Himix, the concrete mixing plant on the rim of the Black Canyon overlooking the dam. It provided concrete for the final 242 feet of the dam and the buildings on its crest. The airline distance from Boulder City to Himix was 6.7 miles. A drop in 1100 feet in elevation however, necessitated ten miles of winding tracks to keep the grades from being too steep.
Six Companies, Inc. built and operated the third segment of the system. The tracks branched off the U.S. Government Construction Railroad at Lawler, about a mile up Hemenway Wash from the Visitor Center. It crossed Hemenway Wash and followed the base of the River Mountains and then looped eastward to the gravel plant on the flat overlooking the Colorado River. One branch went upstream 7.3 miles from the gravel plant to the gravel beds on the Arizona side
Isolation demanded the tons of concrete needed for the dam to be manufactured locally. An electric dragline with a five cubic yard capacity loaded gravel into railroad cars. Concrete was made by mixing sand and crushed rock, called aggregate, with portland cement and water. Over four million cubic yards of aggregate were taken from the Arizona side of the river.
The other branch followed the river downstream into Black Canyon, to Lomix, a concrete mixing plant situated at the base of Black Canyon. Lomix provided the concrete for the diversion-tunnel linings, the powerhouse foundation, and two-thirds of the dam. To prevent the concrete from drying during transportation the mixing plant was put as close to the river as possible.
Locomotives hauled tons of gravel to a screening plant on the other side of the river 24-hours a day. A round trip took slightly over two hours. The foundations of the plant are now about 150 feet below the water level of Lake Mead.
The Six Companies, Inc. Railroad was, of course, abandoned after the completion of Hoover Dam in 1935. The U.S. Government Construction Railroad section was sporadically used until 1961, when the last generator was hauled over its rails and installed at the power plant.
The tracks were dismantled in 1962 and sold as scrap to Lucia Brothers. The tunnels and trail were nominated in 1984 to the National Register of Historic Places.
Today you can walk or bicycle along the elevated railroad bed used to haul supplies and materials for the construction of Hoover Dam. Enjoy the spectacular views of Lake Mead and the surrounding desert landscape.
Walking Tour
Look for desert bighorn sheep, ravens' and owls' nests, lizards, and antelope ground squirrels. You may also see rattlesnakes and scorpions during the summer.
Along the trail you will see a section of rough, rocky road on the south side of the railroad bed that is believed to be the first section of pioneer trail or road for the construction of Hoover Dam. Approaching tunnel 1, on the right, look down the ravine to see concrete plugs taken out of Hoover Dam to install the turbines.
Tunnel 1 has eight sections of vertical supports, five of which have horizontal planks to prevent the fall of loose rock on to the tracks so there would be few delays during the 24-hour dam building schedule. Weight from the rock has damaged the outermost, eastern arch.
Tunnel 2 burned in an arson fire in 1990. You can see it looks different from the other tunnels. It was sprayed with shotcrete to fortify the now looser rock.
Between tunnels 2 and 3, another pioneer road is visible. Rocks excavated from the tunnels were undoubtedly used for the fills you are walking on now.
The outermost east arch was deformed by pressure of the rock in tunnel 3.
Tunnel 5 was burned in 1978 and was then sealed. The tunnel was restored and reopened in July, 2001. The trail now ends on the other side of tunnel 5. The Historic Railroad Trail will continue to Hoover Dam in the future.
All tunnels are 25 feet in diameter. They were oversized to fit huge penstock sections and large equipment being transported to Hoover Dam.
Nine steam and four gas locomotives and 71 people were used to operate the system. It was a standard-gauge, 90-pound rail construction that used Oregon fir ties.
Follow DesertUSA